Bang & Olufsen BeoLink Active - Setting-up Guide - Manual (Page 7)

7
In the link room: Using a Master Link cable, connect the
multi-pin plug to the socket marked MASTER LINK on
the Beo Link Active box, and run the cable to the
junction box.
Using Power Link cables (8-pin DIN), connect your
active speakers to the sockets marked POWER LINK.
Remember to set the L•R•LINE switch on each speaker
to L and R (left and right channel), respectively.
*The socket marked PC is for connection of extra
equipment. You must use the Bang & Olufsen cable
adaptor to make the connection. For further
information, contact your Bang & Olufsen retailer. The
PC source is activated via the PC command on your
Beo4. You can only select the PC source locally.
In the main room: Using a Master Link cable, connect
the flat multi-pin plug to the socket marked MASTER
LINK on the main system, and run the cable to the
junction box. If a PC source is also connected to your
main room TV, you must bring up L-PC from the Beo4
list to activate it in the link room.
Inside the junction box: Join the cables as explained in
the documentation enclosed with the box. This
document contains information of the many
possibilities of the box and how to join the cables.
> Connections
Connect one speaker to the
socket marked Power Link
and then loop the signals
through to the other speaker
as described in the User’s
guide for your speakers.
Master Link
connection
to the main system
PC*
Main System Link System
Junction box BeoLink Active box