Baumfolder 714XLT: Air-Operations Manual (from 2001 thru 2005) - Manual (Page 8)

TP10289-2 PAGE 8
Figure 6.2-1
Gap Knob
6.4 Gap Adjustment
With the machine running, insert two sheets of paper
between the tab and the sucker wheel. Turn the gap knob
counterclockwise until there is a slight drag on the paper.
Remove the paper. The correct gap is now set. (See
Figure 6.4-1)
Figure 6.4-1
D) Locate the point on the chart where the columns
for the type of fold and the sheet size intersect. You will
notice that there are either two letters or a dash and a
letter. These letters and/or dash tell you where to set the
paper stop on the fold plate, and whether or not one of the
fold plates will be installed in the deflector position.
Example #1 ; To make a letter fold to an 8 1/2 x11
sheet, set the paper stops for the #1 and #2 fold plates on
the letter E. No dash appears, so neither fold plate is
installed in the deflector position.
Example #2: To make a single fold to an 8 1/2x11
sheet, install the #2 fold plate in the deflector position.
Set the paper stop for the #1 fold plate at the letter K.
6.3 Paper Stop Adjustment
To move the paper stops to the correct position as
determined in step #2, depress the coarse adjustment
knobs on the paper stop and slide the paper stop until the
indicating edge is aligned with the proper letter on the fold
plate. (See Figure 6.3-1)
To obtain an exact setting on the paper stops, turn
the micro-adjustment knobs until the indicating edge of
the paper stop is perfectly aligned with the line adjacent to
the letter on the plate.
Figure 6.3-1