Baumfolder 714XLT: Thrufold-Cross Carrier idler pulley assy Manual - Manual (Page 6)

TP10388 6
REMOVAL AND INSTALLATION
OF IDLER PULLEY ASSEMBLY
1. DISCONNECT POWER FROM MACHINE.
2. REMOVE CROSS CARRIER BELT GUARD AND TIE BAR ACCESS GUARD, ITEMS 11 & 12.
REFERENCE TP268-299-01-0 SECTION 2-3 OF PRESENT MANUAL. REMOVE DRIVE BELT
ITEM 7 FROM IDLER PULLEY, REFERENCE TP267-802-01-1 SECTION 2-6 OF PRESENT
MANUAL.
3. REMOVE CROSS CARRIER FROM FOLDER AND PLACE ON A FLAT WORKING AREA FOR
SERVICING.
4. REMOVE SET SCREW ITEM 4 HOLDING IDLER PULLEY ITEM 11 IN BOTTOM SIDE OF
RIGHT HAND CROSS CARRIER FRAME. CAREFULLY REMOVE IDLER PULLEY ASSEMBLY.
REFERENCE TP267-802-01-1 SECTION 2-6 OF PRESENT MANUAL.
5. INSTALL NEW IDLER PULLEY ASSEMBLY FK2000262 INTO CROSS CARRIER FRAME.
RE-INSTALL SET SCREW ITEM 4 AND PRIOR TO TIGHTENING CHECK TO MAKE SURE
THAT YOU HAVE .030” CLEARANCE BETWEEN OUTSIDE DIAMETER OF LARGE THRUST
WASHER ON IDLER PULLEY ASSEMBLY AND RIGHT HAND CROSS CARRIER FRAME.
REPLACE GEAR BELT ITEM 6 ON CROSS CARRIER DRIVE ROLL AND IDLER PULLEY
ASSEMBLY ITEM 11 BEFORE SEATING SET SCREW ITEM 4. REFERENCE
TP267-802-01-1 SECTION 2-6 & -7 OF PRESENT MANUAL.
6. RETURN CROSS CARRIER TO FOLDER AND INSTALL ROUND DRIVE BELT ITEM 7 ALONG
WITH CROSS CARRIER BELT GUARD AND TIE BAR ACCESS GUARD, ITEMS 11 & 12.
REFERENCE TP267-802-01-1 SECTION 2-6 7 -7 OF PRESENT MANUAL.
7. RECONNECT POWER AND RESUME FOLDING.