Baumfolder 714XLT: Batch Ctr Manual - Manual (Page 3)

PAGE 3 T P 1 0 3 0 2 A
1.0 SOUND COVER INSTALLATION
INSTRUCTIONS
1) Getting Started
It’s very important that you follow these instructions
in the sequence noted. Read the instructions carefully
before proceeding with the actual work.
WARNING
Make certain that the 714XLT is unplugged.
Do not plug the power cord into an AC outlet
until the XLT is fully re-assembled, adjusted and
ready to use. Unplug the XLT any time
disassembly is required.
Find a suitable table upon which to set the XLT if not
already mounted to the Baum USA optional carts
(P/N 55849-001 or 279-834-BG-01).
1) Locate and remove the plugs (4) on the back of the
non-operator side guard.(See figure 1, Item 1) These
holes are for mounting the rear sound cover door.
2) Remove the guard from the non-operator side by
removing the four button head screws; using a
an allen wrench.
3) Mount the bottom half of the hinge(Figure 2, Item 1)
to the hinge mounting bracket(Figure 2, Item 2) so that
the plastic side guard is clamped between them.(Figure
2, Item 3)
4) Make certain that the screws do not penetrate into
the opening for the hinge pin.
Set aside panel until re-installation operation.
Figure 1
1
2
3
Figure 2
1