0 assembly – Baumfolder Flexifold: 1st Station (in 2004) User Manual

Page 22

Advertising
background image

TP10494

PAGE 22

Figure 4.1-1

WARNING

Do not plug the power cord into an AC outlet until

the Flexifold Air Feed is fully assembled, adjusted and

ready to use. Unplug the Flexifold any time disassembly

is required.

4.0 ASSEMBLY

4.1 Main Unit

To assemble the Flexifold Air Feed unit, first remove

the four bolts holding it to the skid. Place the folder on the

stand (See Figure 4.1-1).

4.3 Pump Hose Connections

Two hoses come with your Flexifold Air

(See Figure 4.3-1)

Air

Vacuum

For

Pump

Hoses

Figure 4.3-1

4.2 Pump Electrical Connections

The pump has a plug/cord set attached. This plug fits

directly into the rear of the left-hand side cover.

(See Figure

4.2-1)

Pump

Plug/Cord Set

Figure 4.2-1

4.4 Delivery Table

To install the delivery table, insert the delivery table

with the drive wheel toward the fold rolls. Slide the deliv-

ery table over both sets of locating pins.

The first notch in the front part of the delivery table

should rest on the pins. Then drop the rear notch down on

the rear dowel pins.

Rotate the handwheel to check that the gears are

properly meshed.

Plug the delivery table into the table receptacle on

the input/output Power assembly.(

See Figure 4.2-1)

4.5 Feed Table Assembly Installation

Insert the feed table with the feed wheel toward the

fold rolls. Slide the paper feed table over both sets of

locating pins.

The first notch in the front part of the feed table

should rest on the pins. Then drop the rear notch down on

the upper dowel pins.

Rotate the handwheel to check that the gears are

properly meshed.

Connect the feed table hoses. Push the fittings into

the holes in the manifold block.

(See Figure 4.5-1)

Delivery Table Receptacle

Advertising