Baumfolder BAUM20: Perforating instructions - Manual (Page 3)

Perforating Continued:
Slide all accessories onto the slittershaft and leave all
items loose. Use the yellow scribe marks on the exit tie
bar to line up the perforating blades or pull up on the
#1 and #3 foldplates and roll a marked sheet of paper
through the folder and line up the perforating blades
with the marks on the lead edge of the paper and
place the pullout tires close to the perforating blades
and at the edges of the sheet. Reinstall the slittershaft
housing and tighten the holding knob back into the
upper position.
Line up all the accessories and rotate them so that all
of the setscrews are at the same position facing
outward and tighten the setscrews. This reduces setup
time for the next job having all of the setscrews at the
same position.
Mount the springsteel stripper assembly onto the exit
tiebar that has the yellow scribe marks as shown. The
stripper is to be mounted beside the perforating blade.
It does not straddle the blade. YOU MUST USE THE
STRIPPER TO PERFORATE!
Set the adjustable depth to the nominal center position
using the micrometer adjustment knobs at each end of
the slittershafts. The milled notch at the center of the
aluminum block is the nominal center adjustment.
To adjust the perforation position, you can use the
microadjustment knob on the register table. This is
only effective when one perforation is being adjusted.
It will not adjust multiple perforations.