Burley Piccolo - Manual (Page 4)

Trailercycle Assembly
1. Mount pedals (stamped R for right and L for left) to
corresponding crank arm and tighten.
2. With screw, mount reflector bracket on left seat stay.
Fasten reflector to bracket with mounting screw.
3. Slide flag into bracket.
4.
PICColo onlY: Fasten splashguard to stem with two
6 mm bolts supplied with fender.
5. Insert seat post into seat tube. Tighten quick release
lever. Ensure that the minimum insertion mark, or at
least 2 ½” (63.5mm) on the seat post remains inside
the frame.
6. To install handlebar, remove face plate, place
handlebar into clamp and replace face plate, clamping
handlebar to stem. Center handlebar in stem.
Tighten bolts.
7. Insert trailercycle tongue into hitch spindle and
tighten both nuts securely. PHOTOS 2A AND 2B
2A Before tongue insertion
2B After nuts tightened
1 STEPS 1 THROUGH 5
1
2
3
4
5
IMPORTANT
FOLLOW ALL ASSEMBLY INSTRUCTIONS CLOSELY.
4 B U R L E Y P I C C O L O A N D K A Z O O O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L