Bird Technologies ACMI - Manual (Page 14)

2
Component Description
Figure 1 Antenna & Cable Monitor Outline
1 RF Input Connects to the amplifier or combiner
2 Forward Monitor Port Samples the forward travelling wave
3 Reflected Monitor Port Samples the reflected wave
4 RF Output Connects to the antenna or feeder
5 Reset Switch Resets the alarm. If an alarm trigger is still present,
the alarm will reactivate
6 Operation/Test LED Green LED indicates when the unit is powered
7 Alarm LED Red LED indicates when an alarm is triggered
8 Ethernet Port RJ-45 connector. Interface to a PC using a Cat5
Ethernet cable
9 Power/Alarm Parallel
Port 15 pin female connector. Connects to the power
supply using a male 15 pin cable. Also used for
remote operation.