Bird Technologies 5000-XT-Manual - Manual (Page 62)

48
Figure 5 Back Cover Removal
1. Lay the DPM, display side down, on a clean surface.
2. Remove the two mounting screws from the back cover.
3. Remove the back cover.
Note: Take care to not disconnect the battery connector.
4. Pull the battery strap and remove the old battery.
5. Install the new battery.
Note: Check the orientation of the positive and negative terminals.
6. Replace the back cover.
7. Secure the back cover with the mounting screws.
Back
Cover
Mounting
Screws
Battery
Battery
Strap