Blizzard Lighting Blade QFX(Rev A) - Manual (Page 13)

Page 13
Blade™ QFX User Manual Rev. A (c) 2013 Blizzard Lighting, LLC
Selecting A Fixture ID
To setup or use a fixture ID, push the <MENU> button until you reach the DMX512
screen. Press the <ENTER> button once, and note that the digits located at the
bottom left are underlined. This is the fixture ID, and its assigned starting DMX
address is to to right. To use a different fixture ID, push the <UP/DOWN> buttons to
until you reach your desired ID number.
Changing A Fixture ID Starting DMX Address
After you’ve reached your desired ID number, push the <ENTER> button once, and
you’ll notice that its assigned DMX address on the right is now underlined and ready
for editing. Use the <UP/DOWN> buttons to select your desired DMX address
anywhere from
001-255 . Push <ENTER> confirm (See page 12 for more info.)
DMX Mode Selection
To use the fixture in either 13CH, or 25CH DMX channel mode, use the <UP/
DOWN> buttons to scroll to Channel, and push the <ENTER> button . Next, use the
<UP/DOWN> buttons to scroll to either 13CH or 25CH . Then push the <ENTER>
button to confirm your choice .
Sound Active Mode
In sound active mode, the fixture will react to sound, chasing through the built-in
programs. To use the fixture in sound active mode, use the <UP/DOWN> buttons
to scroll to
Master Sound, then push the <ENTER> button . Next, use the <UP/
DOWN> buttons to select the microphone sensitivity level from 00 to 99 (high <-->
low). Then push the <ENTER> button to confirm your choice.
Auto Mode
In auto mode, the fixture will automatically chase through its built-in programs. To
use the fixture in auto mode, use the <UP/DOWN> buttons to scroll to
Master
Auto, then push the <ENTER> button . Next, use the <UP/DOWN> buttons to
select the auto mode of your choice from 00 to 15. This will adjust the speed (fast
<--> slow). Then push the <ENTER> button to confirm your choice .
Program Mode (Built-in Programs)
To use the fixture in program mode, use the <UP/DOWN> buttons to scroll to
Master Prog, then push the <ENTER> button . Next, use the <UP/DOWN>
buttons to select the individual built-in program of your choice from 00 to 22 . Then
push the <ENTER> button to confirm your choice .
Fade Mode
To adjust the fade speed, use the <UP/DOWN> buttons to scroll to Master Fade,
then push the <ENTER> button . Next, use the <UP/DOWN> buttons to select the
fade rate of speed from 00 to 15 (fast <--> slow). Then push the <ENTER> button
to confirm your choice .