Blizzard Lighting COBZilla Bright White 5X5 Matrix - Manual (Page 12)

Page 12
CobZilla™ Bright White 5X5 Matrix Manual Rev. A Copyright (c) 2010-14 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page #16.
1.) The COBZilla™ Bright White 5X5 Matrix is capable of operating
with 1, 4, 25, or 28 DMX channels. To select the channel mode that you desire,
First press the <MODE> button to select
d001
on the LED Readout.
Then press the <SETUP> button to select channel mode,
1-ch, 4-ch,
25ch
or
28ch
. Use the <UP> or <DOWN> to select desired channel.
Auto, Master/Slave, Sound Active & Character Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the fixture in Auto mode, select
AUTO
using the <MODE> button.
2.) To use the fixture’s built-in programs, select
Pr.01-27
, using the
<MODE> button then the <UP> and <DOWN> buttons to choose desired pro-
gram. Press the <MODE> button to exit out of the menu.
3.) Each fixture is a master by default. To set the fixture as a slave, use the
<MENU> button to reach
SLAv,
then press the <SETUP> button select
a mode.
SLAv 1 -1, 1 - 2, 2 -1, 2 - 2
. Using the <UP> and
<DOWN> buttons. When the user joins four devices, as shown below, the
devices will work as one unit.
Host
1-2
2-1 2-2
4.) Press the <MODE> button to exit out of the menu.
Sound Active Mode:
1.) To use sound active mode, select
SouD
by pressing <MODE>.
2.) Press the <SETUP> button to change built-in program
SU.00-31
by
using the <UP> and <DOWN> buttons.
3.) Press the <MODE> button to exit out of the menu.
Character Mode (Individual Letters and Numbers Mode):
Allows a single fixture to display a variety of individual letters or numbers without a DMX
controller. (Would be really cool with multiple fixtures! Hint... Hint...)
1.) Press the <MODE> button to reach
ChAr.
Then press the <SETUP> but-
ton to select Letter mode or Number mode.
2.) Use the <SETUP> button to select which letter or number you want the
fixture to display. Use the <UP> and <DOWN> buttons to select
PA A - Z
under
Lett
or
PA 0 - 9
under
nUbe.
3.) Press the <MODE> button to save and exit.