Blizzard Lighting Q Flurry(Rev C) - Manual (Page 11)

Page 11
Flurry Q Manual Rev. C Copyright (c) 2011-12 Blizzard Lighting, LLC
Control Panel Menu Structure
**HOLD The <MENU> Button for 5 seconds to confirm any function. **
Display Selection Function
Addr A001
-
A512
Sets the fixture DMX Address & Sets
the fixture to DMX Mode.
ChNd
7Ch
-
12Ch
Sets the fixture in 7 (Basic) or 12 (Ex-
tended) DMX channel mode.
SLNd
NAST
-
SL 1
-
SL
2
Sets the fixture’s profile as Master
(NAST), Slave Mode 1 (SL 1), or Slave
Mode 2 (SL 2).
SouN 0 - 100
Sets the fixture in Sound Active mode,
and sets the sound sensitivity of the
unit’s internal microphone.
AuTo No - YES Sets the fixture in Auto Run mode.
STbY No - YES
Sets the unit to enter “Standby Mode”
when not receiving DMX signal, other-
wise the unit will automatically enter
Master/Slave Mode.
PAN No - YES
Sets the pan function to normal (NO) or
inverse (YES).
TILT No - YES
Sets the tilt function to normal (NO) or
inverse (YES).
dISP dSIP Sets the display to normal or inverted.
TEST <ENTER> Sets the fixture in internal test mode.
hour <ENTER>
Displays the fixture’s total running
hours.
rSET <ENTER> Resets the fixture.
BALA
rEd - GrEE -
bLuE - UhIT
Adjusts the color balance of each color
between 0 (lowest) and 255 (highest)
NOTE: Color balance adjustment is accessed by holding the <ENTER> button
for 5 seconds while in any operating mode.