Page 16 – Blizzard Lighting HotStik User Manual
Page 16
Page 16
HotStik™ User Manual - Rev. A
(c) 2013 Blizzard Lighting, LLC
Troubleshooting
Symptom
Solution
Beam is Dim
Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position,
if applicable.
No Light Output Check to ensure fixture is operating under correct mode,
IE auto/DMX/Etc., if applicable. Contact service for more
information.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power
Check fuse, AC cord and circuit for malfunction.
Blown Fuse
Check AC cord and circuit for damage, verify that moving
parts are not restricted and that unit’s ventilation is not
obstructed
Fixture Not
Responding /
Responding Er-
raticly
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
If your problem isn’t listed, or if problems persist,
please contact support: [email protected].