Blizzard Lighting 5 COB HotStik - Manual (Page 14)

Page 14
HotStik™ 5 COB User Manual - Rev. A (c) 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button
repeatedly until you find either
d.001
(5ch mode), or
A.001
(9ch
mode). To change the DMX starting address within either of these, use
the <UP/DOWN> buttons to scroll from
001 to 512 . Press <ENTER>
to confirm your choice.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user
selectable speeds.
1.) To set the fixture in Color Fade mode, select CF.-- . Then use the
<UP/DOWN> buttons to scroll from CF.01 to CF.99 (Slow <--> Fast).
2.) To set the fixture in Color Change mode, select CC.-- . Then use the
<UP/DOWN> buttons to scroll from CC.01 to CC.99 (Slow <--> Fast).
3.) To set the fixture to display any of its built-in Color Macros, select
CS.-
- . Then use the <UP/DOWN> buttons to scroll from CS.01 to
CS.99 (Slow <--> Fast).
4.) To set the fixture as a slave unit, simply daisy chain 2 or more units
via DMX. The 1st fixture in the chain will serve as the master, and the
following fixtures will act as the master unit does.
Auto/Demo Mode:
1.) To set the fixture in Auto mode, select DENO .
Sound Active Mode:
1.) Sound active mode is available via 9ch DMX Mode between the
values of 240 <--> 255.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture.
1.) Use the <MENU> button to select r.--- (Red Level), 9.--- (Green
Level), b.--- (Blue Level), Y.--- (Amber), or U.--- (White Level), then
hit <ENTER>.
2.) Using the <UP/DOWN> buttons, select the maximum level for
each color between
000x255 (000=off), then hit <ENTER> to confirm.