Blizzard Lighting Seven-3 ProPar (Rev B) - Manual (Page 12)

Page 12
ProPAR Seven.3 Manual Rev. B Copyright (c) 2013 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
ADDR
on the LED Readout. To select a different DMX address, hit the
<ENTER> button and use the <UP/DOWN> buttons to select the
correct address, then hit <ENTER> to confirm.
Auto, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user
selectable speeds.
1.) To use the fixture in 3 channel or 6 channel mode, use the
<MENU> and <UP/DOWN> buttons to select
CHND
and hit the
<ENTER> button. Then use the <UP/DOWN> buttons to select
either
3CH or 6CH.
Press the <ENTER> button to confirm.
2.) To set the fixture in automatic mode, use the <MENU> and <UP/
DOWN> buttons to select
SHND,
hit <ENTER>. Then use the <UP/
DOWN> buttons to select
COLO
and hit <ENTER>. Then use the
<UP/DOWN> buttons to select
AUTO
, and press <ENTER>.
3.) To use the fixture as either a master or slave unit, use the
<MENU> and <UP/DOWN> buttons to select
SLND
and then hit the
<ENTER> button. Then select either
NAST
for master or
SLAU
for
slave. Press the <ENTER> button to confirm.
4.) To adjust the speed of the chase navigate to
FADE,
hit <ENTER>,
and select
SP 1
(slowest) to
SP 8
(fastest). Press the <ENTER>
button to confirm.
Sound Acitve Mode:
1.) To use this fixture in sound active mode, select
SHND
, then press
the <ENTER> button. Then select
SOUN
and hit enter.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are
global, they will effect all modes.
1.) use the <MENU> and <UP/DOWN> buttons to select
NANU
and
hit the <ENTER> button.
2.) Then use the <UP/DOWN> buttons to scroll to either
RED
(red),
GREE
(green), or
BLUE
(blue), and press <ENTER>. Select
the maximum level for each color between 0-255 (0=off), then hit
<ENTER> to confirm.