Blizzard Lighting COB Raygun - Manual (Page 12)

Page 12
RayGun™ COB Manual Rev. A © 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the DMX Starting Address:
1.) The default mode for the fixture is DMX, which appears as ADDR on the LED
readout. To select a different DMX address, hit the <ENTER> button and use the
<UP/DOWN> buttons to select the correct address, then hit <ENTER> to confirm.
DMX Channel Mode:
1.) To use the fixture in 4 channel or 7 channel mode, use the <MENU> and <UP/
DOWN> buttons to select CHND and hit the <ENTER> button. Then use the <UP/
DOWN> buttons to select either 4CH or 7CH. Press the <ENTER> button to confirm.
Master/Slave Mode:
1.) To use the fixture as either a master or slave unit, use the <MENU> and <UP/
DOWN> buttons to select SLND and then hit the <ENTER> button. Then select
either NAST for master, SL 1 for slave mode 1, or SL 2 for slave mode 2. Press the
<ENTER> button to confirm.
Auto Mode, Fade/Strobe Speed, & Sound Active Mode
Allows a single or Master/Slaved units to run factory installed programs at user
selectable speeds.
Auto Mode:
1.) To set the fixture in automatic mode, use the <MENU> and <UP/DOWN> buttons
to select SHND, hit <ENTER>. Then use the <UP/DOWN> buttons to select COLO
and hit <ENTER>. Then use the <UP/DOWN> buttons to select AUTO , and press
<ENTER>. You will then be prompted to select the chase speed by selecting from SP 1
(slowest) to SP 8 (fastest). Then hit <ENTER> to confirm.
Fade Speed:
1.) To adjust the fade speed navigate to FADE, hit <ENTER>, and select SP 1
(slowest) to SP 8 (fastest). Press the <ENTER> button to confirm.
Strobe Speed:
1.) To adjust the strobe speed navigate to STCO, hit <ENTER>, and select between
0-255 (slow <--> fast).
Sound Active Mode:
1.) To use this fixture in sound active mode, select SHND, then press the <ENTER>
button. Then select SOUN and hit <ENTER>.
Manual Color Adjustment
Allows the user to adjust the color balance of the fixture. These settings are
global, they will effect all modes.
1.) Use the <MENU> and <UP/DOWN> buttons to select NANU and hit the
<ENTER> button.
2.) Then use the <UP/DOWN> buttons to scroll to either RED (red), GREE (green),
BLUE (blue), or Uhlt (White), and press <ENTER>. Select the maximum level for each
color between 0-255 (0=off), then hit <ENTER> to confirm.