Blizzard Lighting The Puck Fab5 (Rev A) - Manual (Page 10)

Page 10
The Puck™ Fab5 User Manual Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
nOTE: After making any change, the unit will return to the correct mode in about 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
Addr
on the LED
Readout. Use the <EnTER> button then the <UP> and <DOWn> buttons to
choose a channel between
1
and
512
. Press <EnTER> again to confirm.
2.) To change between 3 and 6 channel DMX mode, select
ChNd,
then press
<EnTER>. Select either
3Ch, 5Ch
or
12Ch
, then press <EnTER> again to
confirm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
1.) Use standard DMX cables to daisy chain your units together via the DMX
connector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must be
the first unit. Finally, chain the units together using DMX cable.
Master
SLNd
then
NASt
to confirm.
3.) Select slave function by using the <UP>/<DOWn> keys to reach SLAV in the
Master/Auto menu on the slave units, and they will react in the same as the Master.
Slave
SLNd
then
SLAu
to confirm.
nOTE: When a unit is set to slave and no master is connected,
Stby
will
appear on the LED display.
4.) On the master fixture, use the <UP>/<DOWn> keys to reach
SHND
, which
allows you to select the following:
Sound active
SoUn
then <EnTER> to confirm.
Auto mode
CoLo
then
Auto,
then <EnTER> to confirm.
Color preset
CoLo
then
CoL 1 - CoL 31,
<EnTER>
Color strobe
StCo
then
0-255
(Slowest <-.-> Fastest)
then
CoL 1 - CoL 31,
<EnTER>
To set a custom color in Master/Slave/Standalone Mode:
Using this function, you can select any color by adjusting the Red, Green, Blue, Amber and
White values from 0-255. You may also adjust the color balance of the fixture.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this mode.
1.) Select
NAnu
from the control panel, then hit <EnTER>.
2.) Choose
rEd, GrEE
,
bLuE, ANbE or Uhit
, then hit <EnTER> to
confirm.
3.) Using the <UP>/<DOWn> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <EnTER> to confirm
each color choice.
4.) Select Color preset mode as instructed above, then select
CoL 15.
then
<EnTER> to confirm.