Blizzard Lighting Quadra ToughPAR (Rev C) - Manual (Page 12)

Page 12
ToughPAR Quadra Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
d001
on the LED
Readout. To select a different DMX address, using the <MENU> button, select
Addr
,then hit <ENTER>. Use the <UP/DOWN> buttons to select the correct
address, then hit <ENTER> to confirm.
Stand-Alone, Master/Slave Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the fixture in Flash/Fade mode, select
FLAS or FAdE
To confirm, press the <ENTER> button.
2.) Now, select the flash or fade speed using <MENU> button to reach
SP--
,
then hit <ENTER>.
The display reads
SP15
(slowest) to
SP00
(fastest), then press the <EN-
TER> button to confirm.
3.) To use the fixture in automatic mode, select
ASC-
, then press the <EN-
TER> button to confirm.
4.) Adjust the speed of the chase as above using
SP15
(slowest) to
SP00
(fastest) then press the <ENTER> button to confirm.
5.) To set the fixture as a slave unit, select
SLAV
, and hit <ENTER>. The unit
will display a flashing
SL-U
to indicate it is in slave mode.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fixture in manual mode, select
Pr--
.
To confirm, press the <ENTER> button.
2.) Now, select the program by using the <UP> and <DOWN> buttons to select
Pr00-Pr15
. To confirm, press the <ENTER> button.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are global, they
will effect all modes.
1.) Use the <MENU> and <UP/DOWN> button to select
rL--
(Red Level),
GL--
(Green Level),
bL--
(Blue Level) or
UL--
(White Level), then hit
<ENTER>.
2.) Using the <UP/DOWN> buttons, select the maximum level for each color
between
x000-x255
(000=off), then hit <ENTER> to confirm.