Blizzard Lighting EXA ToughStick - Manual (Page 12)

Page 12
ToughStick™ EXA User Manual Rev. A Copyright 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Setting the Starting DMX Channel:
1.) The default mode for the fixture is DMX, which appears as d001 on the LED readout.
To select a different DMX address, using the <MENU> button, select Addr, then hit
<ENTER>. Use the <UP/DOWN> buttons to select the correct address, then hit <EN-
TER> to confirm.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button, then use the <UP> or
<DOWN> buttons until the display reads Chnd and press the <MENU> button. Then
use the <UP> or <DOWN> buttons until the display reaches your desired channel
mode. Press the <MENU> button to confirm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
1.) To set the fixture in Flash or Fade mode, select FLAS or FAdE. To confirm, press the
<ENTER> button.
2.) Now, you can adjust the flash settings from FL00-FL15 or the fade settings from
FA00-FA15. Then press the <ENTER> button to confirm.
3.) To use the fixture in automatic mode, select ASC-, and press the <ENTER>
button. Then use the <UP/DOWN> buttons to choose from AS00-AS15. Now press
<ENTER>.
4.) Adjust the speed of the chase as above using SP15 (slowest) to SP00 (fastest) then
press the <ENTER> button to confirm.
5.) To set the fixture as a slave unit, select SLAU, and hit <ENTER>. The unit will
display a flashing SL.AU to indicate it is in slave mode.
Sound Active Mode:
1.) To use sound active mode, select SouA, then press the <ENTER> button to confirm.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fixture in manual mode, select Pr--. To confirm, press the <ENTER>
button.
2.) Select the program by using the <UP> and <DOWN> buttons to select Pr00-Pr15.
3.) To confirm, press the <ENTER> button.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are global, they will
effect all modes.
1.) Use the <MENU> and <UP/DOWN> buttons to select either rL-- (Red Level), GL--
(Green Level), bL-- (Blue Level), AL-- (Amber Level), IL-- (White Level), or UL (UV
Level), then hit the <ENTER> button.
2.) Using the <UP/DOWN> buttons, select the maximum level for each color between
x000-x255 (000=off), then hit <ENTER> to confirm.