Blizzard Lighting 252 ToughSTORM (Rev A) - Manual (Page 12)

Page 12
ToughSTORM™ 252 Manual - Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default starting DMX address for the fixture is
A001
on the LED readout. To select a different
starting DMX address, press the <MENU> button, and then use the <UP/DOWN> buttons to navigate to
Addr
, and press the <ENTER> button. Then use the <UP/DOWN> buttons to select the starting address
you wish to use, and press the <ENTER> button to confirm yout choice.
2.) To select which channel mode you would like to use, press the <MENU> button, and then use the
<UP/DOWN> buttons to navigate to
CHnd
and press the <MENU> button, and then use the <UP/
DOWN> to select tour choice of either 3/5/9/13 or 14-channel modes. Press the <ENTER> button to
confirm your choice.
Stand-Alone, Master/Slave Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
Flash/Strobe
1.) To adjust the flash setting (strobe), navigate to
FLAS
and press the <ENTER> button.
2.) Then to adjust the flash speed use the <UP/DOWN> buttons to select from
FL00
(fastest) to
FL15
(slowest). Press the <ENTER> button to confirm your choice.
Color Fade
1.) To adjust the fade settings, navigate to
FAdE
and press the <ENTER> button.
2.) Then to adjust the fade speed use the <UP/DOWN> buttons to select from
FA00
(fastest) to
FA15
(slowest). Press the <ENTER> button to confirm your choice.
Auto Mode
1.) To use the fixture in automatic mode, navigate to
ASC-
and press the <ENTER> button.
2.) Then to adjust the speed use the <UP/DOWN> buttons to select from
AC00
(fastest) to
AC15
(slowest). Press the <ENTER> button to confirm your choice.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To use the built-in programs, navigate to
Pr--
and press the <ENTER> button.
2.) Then to select a program use the UP/DOWN buttons to select from
Pr00
to
Pr15
. Press the <EN-
TER> button to confirm your choice.
3.) You can then adjust the speed of the chase by pressing the <MENU> button, and then use the <UP/
DOWN> buttons to navigate to
SP--
and press the <ENTER> button. Then use then <UP/DOWN>
buttons to select from
SP00
(fastest) to
SP15
(slowest). Press the <ENTER> button to confirm.
Program #0: Red, Full Bar
Program #1: Green, Full Bar
Program #2: Blue, Full Bar
Program #3: Yellow, Full Bar
Program #4: Aqua, Full Bar
Program #5: Magenta, Full Bar
Program #6: White, Full Bar
Program #7: Red + Magenta, 3-Pixel Effect Program #8: Multi-Color Full Bar, Fade Effect
Program #9: Green + Yellow, 3-Pixel Effect
Program #10: Magenta + Green, 3-Pixel Effect
Program #11: Multi-Color 3-Pixel Effect
Program #12: Red, Green, Blue 3-Pixel Effect
Program #13: Red, Green, Magenta 3-Pixel Effect
Program #14: Yellow, Magenta, Aqua 3-Pixel Effect
Program #15: All Program Chase
Slave Mode
1.) To set the fixture as a slave unit, navigate to
SLAU
, and hit <ENTER>. The menu display will then
display
SL-U
. Press the <ENTER> button to confirm your choice.