Blizzard Lighting Weather System COB - Manual (Page 13)

Page 13
Weather System COB User Manual Rev. A Copyright (c) 2014 Blizzard Lighting, LLC
Sound Active Mode:
1.) To use this fixture in sound active mode, scroll to SU-- using the <MODE>
button. Then using the <UP/DOWN> buttons, choose the built-in sound active
chase pattern. Adjusting the settings from SU01 - SU31 will adjust the built-in
microphone sensitivity level (low <--> high).
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are global, they
will effect all modes.
1.) Use the <MODE> button to navigate to Colr and hit the <SETUP> button.
2.) Now you can navigate to r255, 9255, or b255 and use the <UP/DOWN>
buttons to adjust the global intensity of red, green, or blue from 000 - 255.
The Weather System COB™ Foot Switch Controller
Pedal 1 - Auto Run
When you step on pedal 1 on the foot controller, it will set your fixtures to run in
auto mode. To step on petal 1 again from here, it will skip to the next program (2-
14), and then continue to run the programs in sequence from that point.
Pedal 2 - Sound Active
When you step on pedal 2 on the foot controller, it will set your fixtures to run in
sound active mode. The built-in microphone sensitivity settings are adjustable from
the LED control panel menu.
Pedal 3 - Freeze
When you step on pedal 3 on the foot controller, it will freeze/suspend the currently
running program. Step on pedal 3 again, and the Weather System COB™ will con-
tinue running the suspended program.
Pedal 4 - Blackout
When you step on pedal 4 on the foot controller, it will blackout the currently run-
ning program. Step on pedal 4 again, and the Weather System COB™ will continue
running the program where it left off.