Blizzard Lighting Kontrol 6(Rev. A) User Manual
Page 13
KONTROL 6 Manual Rev B.
Page 13
© 2014 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
2. Press the <RUN MODE> button until the LED indicator for MANUAL
mode is illuminated.
3. Using the <LEFT/RIGHT> buttons, move through the steps in the
selected chase.
3.5.4 Playback Override
Allows the user to manually override the current output while in Color/Scene
Preset or Chase Playback Mode.
1. Ensure that BLACKOUT mode is not selected, IE that the LED indicator
above the <BLACKOUT> button is not lit.
2. Using the <FIXTURE SELECTOR> button(s), select the fixtures to be
controlled.
3. Adjust the color output using <FADER 1-6> as desired.
4. To return to Color/Scene Preset or Chase Playback Mode, press <DEL/
CLEAR>.
3.5.5.1 Strobe Setup
Allows the user to set the channel/channels which will be controlled by the
strobe function, for each fixture.
1. Enter programming mode as described in Section 3.2.1.
2. Press the <STROBE> button.
3. Using the <FIXTURE SELECTOR> button(s), select the fixtures to
setup.
4. Using the <LEFT/RIGHT> buttons, select the channel to adjust.
5. To enable the strobe function on the channel selected, press the
<EDIT/REC> button.
6. To disable the strobe function on the channel selected, press <DEL/
CLEAR>.
7. Repeat steps 2-7 to adjust additional channels/fixtures as desired.
8. Hold <EDIT/REC> for 3 seconds to exit programming mode. The LED
indicator above the <EDIT/REC> button will extinguish.
3.5.5.2 Strobe Playback
Allows the user to strobe the current playback. Note: Strobe operates even
when the <BLACKOUT> button is active.
1. Press and hold the <STROBE> button. All currently selected/operat-
ing fixtures will strobe.
2. Using the <STROBE SPEED> fader, adjust the strobe speed, from 1 to
20 flashes per second.
3. Release the <STROBE> button, and strobing will stop.
3.5.6 Blackout
Allows the user to stop all fixture output immediately (except while strobing is
active).
1. Press the <BLACKOUT> button. All output will cease. The LED indi-
cator will illuminate.
2. Press the <BLACKOUT> button again, and playback will resume.