Transport instructions, Disposal, Appliance setup – Blomberg FSM 9550 User Manual

Page 8

Advertising
background image

en

en

2

Transport instructions

The appliance should be transported only in

upright position.

The packing as supplied must be intact during

transportation.

If the appliance is transported in the horizontal

position, it must be placed vertically and left

in this position for 4

hours

before taking into

operation.

The appliance must be protected against rain,

moisture and other atmospheric influences.

The manufacturer assumes no liability if safety

instructions are disregarded.

Disposal

Make the appliance unusable immediately.

Pull out the mains plug and cut the power

cable. Remove or destroy snap or latch locks

before disposing of the appliance. In this

manner you prevent children from locking

themselves in and endangering their lives.

Appliance setup

• Do not operate your appliance in a room

where the temperature is likely to fall below

10 °C at night and/or especially in winter. At

lower temperatures the appliance may not

operate, resulting in a reduction in the storage

life of the food.

• The climate class rate of your appliance is

given on the rating label located inside the

appliance. It specifies the appropriate operating

ambient temperatures as explained below.

Climatic class

Ambient temperatures

SN.......................+10 °C to 32 °C

N .........................+16 °C to 32 °C

ST .......................+18 °C to 38 °C

T..........................+18 °C to 43 °C

SN-ST .................+10 °C to 38 °C

SN-T ...................+10 °C to 43 °C

Location

Only place the appliance in dry rooms which

can be ventilated.

Avoid direct sunlight or direct heat sources

such as a stove or a heater.

If this cannot be avoided, the following

minimum distances should be maintained:

From cookers

:3.00 cm

From heaters

:3.00 cm

From cooling devices

:2.50 cm

• Make sure that sufficient room is provided

around the appliance to ensure free air

circulation.

Fit the two plastic wall spacers supplied with

the appliance rotating 1/4 turn to the condenser

at the back of the appliance (Fig. 6).

• The appliance should be located on a level

surface. The two front feet can be adjusted as

required. To ensure that your appliance is

standing upright adjust the two front feet by

turning clockwise or counter-clockwise, until

the product is in firm contact with the floor.

Correct adjustment of feet avoids excessive

vibration and noise.

Electrical connections

Warning

This appliance must be grounded.

• Check whether the power type and voltage

in your region corresponds to the one stated

on the rating label inside the appliance.

• The electrical safety of the appliance is only

assured when the grounding system in the

house is installed in accordance with

regulations.

• When placing the appliance, do not let the

power cable get stuck under it; otherwise the

cable will be damaged.

• Ensure that the plug remains readily

accessible. Do not use a multiple adapter bar

or an extension cable.

• The electrical specifications of your appliance

is given on the rating label located inside the

appliance.

• Route power cable to allow easy connection

and disconnection after

installation.

• A contact separator should be used if the

power cable is not accessible. (for built-in

models)

Advertising