Blomberg KWD 9440 X A+ - Manual (Page 20)

EN
19
C
Water system of the refrigerator must
be connected to the cold water line. It
must not be connected to hot water line.
C
No water may be obtained in the
initial startup of the refrigerator. This
is caused by the air in the system. To
discharge air from the system, press
Dispenser latch for periods of 1 minute
until water comes from the Dispenser.
Water flow may be irregular in the
beginning. Irregular water flow will be
normalized after the air in the system is
discharged.
C
At the initial startup of the refrigerator
approx.12 hours must pass before cold
water can be obtained.
C
Water mains pressure must be
between 1-8 bars for the operation of
Ice/Water Dispenser smoothly. For this,
check that 1 glass of water (100 cc) can
be filled in 10 seconds.
C
The first 10 glasses of water should
not be consumed.
C
12 hours must pass to obtain ice
from the Ice Dispenser for the first time.
If there is not enough ice in the ice
dispenser, ice may not be obtained from
ice dispenser.
C
Approximately the first 30 cubes
of ice to be obtained from the Ice
Dispenser must not be used.
C
Always use the water filter when a jug
is not being used.