BLUESHAPE CVS8XW - Manual (Page 13)

13
Battery installation Battery removal
CVS8XW CVS8XW
Insert the battery in the
direction of the arrow
1) Push and hold the button in the direction of
the arrow
2) Pull out the battery in the direction of arrow
In the case when you want to charge more batteries, insert the
additional batteries into the available V-plate adapters.
In the case when an external equipment is plugged into any of the
two accessory XLRs, the charging process will be suspended only on
the related channels: #3 and #4, if connected to XLR of Bank-A; #7
and #8, if connected to that of Bank-B.
The AUX LED will light up and the paused battery LEDs will show
'WAITING'. Once the accessory has been unplugged, the charger will
resume the previous charging sequence and from the same point of
interruption.
PLEASE NOTE THAT THE MAXIMUM LOAD THAT CAN BE
CONNECTED TO ANY XLR OUTPUT MUST NOT EXCEED 110W.
ADDITIONAL SAFETY NOTES
Chargers and/or batteries may become hot during
charging. This is normal. Please consult your
BLUESHAPE dealer if you notice that either a
charger or a battery become excessively hot during
the charging operation.
Be careful not to block the equipment’s ventilation
outlets.
Never insert any metallic or any other objects inside
the equipment through the ventilation openings or
otherwise.