BLUESHAPE MVBELT User Manual
Mvbelt, Belt mount system for v-lock type battery packs
Rev 2.0 - 2008
page 1
MVBELT
Belt mount system for V-lock type
battery packs
The user is being alerted of the importance of going through the literature
accompanying this product and familiarising oneself with the important safety and
operating instructions included.
Introduction:
The BLUESHAPE MVBELT system is designed to provide cameramen with a versatile power
source for their equipment. The unit operates with any V-lock type battery. An efficient DC-DC
converter steps down the battery voltage to a steady 8.4V supply compatible with Mini-DV cameras.
At the same time, a nominal 14.8V is available both through the D-tap connector and the in line XLR
socket provided.
The unit is intended for wearing on a waist belt by means of the large stainless steel spring provided
A large internal heat sink ensures that the device remains at a comfortable temperature for the
comfort of the operator.
The electronics of the unit are housed in a sturdy metal case resistant to impact and daily use.
Although the unit is protected against over-current, it is nevertheless recommended that the
maximum continuous current drawn out from the unit should not exceed 5A.
Main features:
Small light-weight V-Mount system that can be attached to any waist belt (not provided)
Easy to insert and remove
Allows the installation of a single battery of type BV070, BV100, BV140, BV175 or BV210
Provides 3 alternative and simultaneous power sources:
1.
a nominal 14.8V through an XLR connector (pin 4)
2.
steady 8.4V available through the same XLR connector (pin 3)
3.
a nominal 14.8V through a D-Tap connector
Versatile and ideal solution for DV cameras, portable light systems and additional equipment -
power several devices from the same battery.
Special cables with battery eliminators are available to fit the most popular Mini-DV camcorders