BMI Racing DB12RR - Manual (Page 7)

Step 16
Locate the two alloy rear pod plates, the alloy rear
pod plate spacer tube 2 4-40 x 3/8” flat head screws
and 4 4-40 x ¼” flat head screws.
Attach the alloy pod plates to the lower carbon pod
plate with the 4 4-40 x ¼” screws.
Attach the alloy rear pod plate spacer tube to the
allow rear pods with the 2 4-40 x 3/8” screws.
Step 18
Locate and install the two long gray anodized threaded
spacers as shown with 4-40 x ¼” flat head screws
Step 18
Locate and install the two carbon damper
tube/body mount wings as shown with 4-40 x ¼”
button head screws.
Step 19
3. Apply 5000wt silicon diff oil to the pistons and
insert them into the damper tubes.
4. Attach the alloy pivot balls to the bottom of the
pod top plate and the tops pf the side wings as
shown above. Secure them with alloy lock
nuts
5. Attach the carbon pod top plate to the alloy
rear pod plates
6. Snap the ball cups of the assembled damper
tubes onto the pivot balls on the pod top plate
and wings.
Note:
If you feel play between your ball cups and
ball studs, you can place a single layer of
plastic bag material between your ball cup and
ball stud then snap them together. This will
cut and insert a disc of plastic into your ball
cup reducing or eliminating the play. If you
still feel play, repeat the process. We find you
usually need one to two layers to get the
proper feel, no play but totally free movement.
Locate the damper tube parts bag, the rear pod top
plate and 4 4-40 x ¼” flat head screws..
1.Thread a 4-40 x ½” set screw into each of the 4
ball cups from the damper parts bag.
2.Thread a ball cup/set screw assembly into the
ends of each of the damper tube pistons and
damper tubes.