Bonide Wilt Stop Plant Protector Concentrate - Manual (Page 4)

Add WILT STOP® to water not water to WILT STOP®.
Never spray or dip the roots of balled or bare root plants.
Freezing does not harm WILT STOP®. Simply shake well prior to use.
Do not mix WILT STOP® with any other compound. Apply only per label
instructions.
Always soak or water transplants thoroughly prior to applying WILT STOP®.
Sprayers should be rinsed with warm soapy water immediately after each use.
Avoid overspray. Fine finishes can be stained. Wash surfaces sprayed in
error with warm soapy water. Dried film can be dissolved with kerosene.
Do not use on African violets or exotic, slow growing dwarf plants.
WILT STOP® may turn blue spruce and similar species of evergreen a green
color. If this occurs, natural coloring will return with the next season's growth.
Before using WILT STOP® on large numbers of plants, test it under your
conditions on just a few plants first.
Do not use WILT STOP® on any variety of arborvitae, cedar, cypress,
chamaecyparis, juniper, sequoia, dwarf conifer or similar plant species
without testing first.
Thorough coverage is important. Apply WILT STOP® at least 1 hour prior
to rainfall.
Sunlight is needed for the protective film to properly set.
Do not use for winter protection where temperatures drop below – 30°
centigrade.