Safety hardware/tools – Brew Express BE-112 INSTALLATION User Manual
Page 3
IMPORTANT:
Read and follow instructions carefully before installing your BREW EXPRESS™ in-the-wall
COFFEE SYSTEM. Wire the BREW EXPRESS™ to a GFCI ground protected source.
This can be accomplished by:
(A). Wiring the unit directly to a string of outlets that are protected by a GFCI outlet. OR
(B). Wiring the unit with a dedicated line to electrical panel with a GFCI breaker.
FOR BEST RESULTS ITS ADVISED THAT YOU HIRE A QUALIFIED PROFESSIONAL.
Always turn off all power at main electrical panel before attempting to install BREW EXPRESS™.
Improper electrical wiring could cause a fi re hazard. All wiring MUST be performed in accordance with
local electrical codes. Installation must be peformed by a Qualifi ed Electrican only, or equivalent.
Always turn off water supply at source when installing BREW EXPRESS™. Improper installation of water supply
could cause poor performance or leaks which may lead to dry rot and cause structure damage to building.
Be certain water supply is leak free. Hire a qualifi ed plumber if necessary.
The BREW EXPRESS™ dispenses extremely hot water. Hot liquids may cause severe burns if it contacts skin.
Use extreme caution when handling hot liquids dispensed by the BREW EXPRESS™. KEEP HANDS AWAY
FROM SPRAY HEAD, BREW BASKET, CARAFE OR MUG DURING BREW CYCLE. This product is intended
for brewing hot water for beverages only, and may not be used in any other way.
Check distance between wall cavity studs to ensure BREW EXPRESS™ will fi t in desired location.
Normal cavity is 14.5” wide and 4” deep. Hire a qualifi ed professional if necessary.
2
3
SAFETY
HARDWARE/TOOLS
HARDWARE
BREW EXPRESS™ comes supplied with the following items to ensure a successful installation.
Check to be certain all items have been included with your brewer.
•
(1) Brewer (with short water line attached to connect with incoming water line)
•
(1) Rough-in-Box
•
(1) Carafe and lid
•
(2) Brew Baskets
•
(1) Installation Guide
•
(1) Operation Guide
•
(1) Template (for cutting hole for Rough-in-Box)
•
(1) Hardware Kit: (located in foam end cap)
(6) Sheet rock screws for mounting rough-in-box.
(3) Wire nuts
(1) Male Quick Connector (for connection between Coffee System Unit and Rough-in-Box).
(4) Mounting screws for mounting brewer in rough-in-box.
TOOLS AND PARTS REQUIRED (not supplied)
The following tools will be useful for installation:
•
Tape Measure
•
Utility Knife
•
Philips Screw Driver
•
Pencil
•
Wire Stripper
•
Stud Finder
•
Pliers
•
Level
•
Strain relief (3/8" diameter) for electrical wire
•
1/4" Poly or copper line (refrigerator ice maker kit) continuous length recommended.
•
12 - 2 wire (per local code)
•
Electric drill and 7/16" drill bit
•
Valve Connection (optional)
•
Water fi lter (ice maker or drinking water type)