Brew Express BE-110 OPERATION GUIDE - Manual (Page 7)

5
IMPORTANT:
Please read and follow instructions carefully before starting your BREW EXPRESS
in-the-wall COFFEE SYSTEM.
Did you purge water lines during installation to remove any foreign particles (debris) in lines?
Debris in water lines can clog brewer system causing failure, and VOID ALL WARRANTIES.
The BREW EXPRESS dispenses extremely hot water. Hot liquids may cause severe burns if it contacts skin. Use
extreme caution when handling hot liquids dispensed by the BREW EXPRESS. KEEP HANDS AWAY FROM SPRAY
HEAD, BREW BASKET, CARAFE OR MUG DURING BREW CYCLE.
1. Make sure water supply is turned on prior to starting BREW EXPRESS.
The BREW EXPRESS will not operate if there is no water.
2. Make sure power is supplied to the BREW EXPRESS.
3. Turn on power switch, depress button on top of unit. Brew button and LED display will illuminate.
4 . Flush brewing system by running two cycles of water through the brewer. Place brew basket under spray head without coffee
or filter, place empty carafe under brew basket and press the brew cycle button. After brewing cycle is complete, empty carafe
and repeat.
5. Wash carafe and brew basket with warm soapy water.
IMPORTANT REMINDERS
• Always empty carafe prior to starting the unit, otherwise overfilling can occur.
• Use appropriate brew basket with carafe and mug.
HARD-WATER NOTICE:
A filter is required for ALL hard-water supplied water sources. Filter must be suitable for calci-
um carbonate and lime scale- most major brands for commercial coffee filter systems are avail-
able. Brew Express has a hard-water filter available at www.brewexpressdirect.com
START UP