Bully Dog 3070x Pod Mount Adapter - Manual

Depending on how you plan to mount your device, the Armor can be installed in several ways.
If using Bully Dog’s 2 1/16
Pod Mount Adapter (30420),
make a small incision and tear
away the circular piece on the
Armor’s back side, insert the
device into the Armor and
insert the T-slot into the device.
If using Bully Dog’s available Ram Mount
T-Slot Adapter (30600-3), slide the adapter
into position on the device, and then insert
the ball end of the adapter through the
circular hole in the back side of the
Armor.
If using Bully Dog’s standard suction cup
mount (40400-102), first insert the T-slot end
of the mount throught the circular hole in the back
side of the Armor. Attach the device to the T-slot on the
mount and pull both the device and the mount back into the Armor.
C
M
Y
CM
MY
CY
CMY
K
30700-1_inside_v2.pdf 1 8/6/13 3:54 PM