Calculated Industries 4045-B - Manual (Page 14)

14 — Construction Master IV
Entering Dimensions
Linear Dimensions
When entering feet-inch values, enter
dimensions from largest to smallest —
feet before inches, inches before
fractions. Enter fractions by entering
the numerator (top), pressing [ / ]
(fraction bar key) and then the
denominator (bottom). Note: If a
denominator is not entered, the
fractional setting value is used.
Examples of how linear dimensions are
entered:
Dimension Keystrokes
5 Yards
5 [Yds]
5 Feet 1-1/2 Inch 5 [Feet] 1 [Inch]
1 [ / ] 2
17.5 Meters 17.5 [m]
Square and Cubic Dimensions
Examples of how square and cubic
dimensions are entered:
Dimension Keystrokes
5 Cubic Yards
5 [Cu] [Yds]
130 Square Feet 130 [Sq] [Feet]
33 Square Meters 33 [Sq] [m]