Calculated Industries 4015 - Manual (Page 20)

U
SING THE
M
EASURE
M
ASTER
C
LASSIC
Entering Dimensions and Units
When entering feet-inch dimensional val-
ues, you must enter the largest dimen-
sion first — feet before inches, inches
before fractions. To enter fractions of an
inch, enter the numerator (value above
the line), press [/] (fraction bar key) and
then enter the denominator (value below
the line).
numerator 3
fraction bar —
denominator 16
For all other units of measurement, you
can only enter whole numbers or decimal
numbers. You cannot enter combinations
of units (for example, you cannot enter 12
meters 6 centimeters 4 millimeters).
20 – Measure Master Classic
™
4015-UG-B 4/4/03 12:29 PM Page 20