Calculated Industries 8545 - Manual (Page 7)

displays the current fractional denomi-
nator and accesses the fractional setting
mode. See the “
Fraction Setting ” section
for more information.
[Cu] — Cubic Key
Used with a dimension key (feet, inch-
es, yards, meters, etc.) to identify a vol-
ume dimension. Example:
5 [Cu] [Yds] .
[Sq] — Square Key
Used with a dimension key (feet, inch-
es, yards, meters, etc.) to identify an
area dimension. Example:
10 [Sq] [Feet] .
[m] — Meters Key
This is an entry and conversion key
(when used with the
[Conv] key). You
can enter decimal meters or convert a
displayed dimension to decimal meters.
[cm] — Centimeters Key
This is an entry and conversion key
(when used with the
[Conv] key). You
can enter decimal centimeters or con-
vert a displayed dimension to decimal
centimeters.
[mm] — Millimeters Key
This is an entry and conversion key
(when used with the
[Conv] key). You
can enter decimal millimeters or con-
vert a displayed dimension to decimal
millimeters.
User’s Guide – 7