Calculated Industries 4400 - Manual (Page 13)

d Diameter — Enters a Diameter
(Circle) or Outside Diameter
(Polygon). Unitless entries
assumed Inches in U.S. mode;
millimeters in Metric mode.
Calculates circle Area and
Circumference given entered
Diameter. Calculates Diameter
given entered Radius.
H Hex/Polygon — Enters number
of Sides of a Polygon. A
multifunction key that calculates
Interior Angle, Exterior Angle,
Side Length, Outside Diameter,
Inside Diameter, Perimeter and
Area of a Polygon, given the
number of Sides, and either
Side Length, Outside Diameter
or Inside Diameter. Default
number of Sides is 6.
gA Radius — Enters or calculates
a Radius. Unitless entries
assumed Inches in U.S. mode;
millimeters in Metric mode.
Calculates Radius given
entered Diameter.
(cont’d)