Cineo Lighting TruColor HS - Manual (Page 3)

3
General Notes
1. Please read through this manual carefully before operating TruColor HS, and keep this
manual for future reference.
2. There are numerous safety instructions and warnings that must be adhered to for your
own safety.
3. TruColor HS is not intended for residential use. It is intended for use in a professional studio.
4. TruColor HS and DX450 must be serviced by a qualified technician.
5. The TruColor HS and DX450 are rated as IP20 – for indoor use and in a dry environment.
6. Cineo TruColor products are not certified for use in hazardous locations.
7. The TruColor HS has a typical operating temperature of 55°C (130°F).
Fixture Set Up
1. Read these safety instructions carefully to ensure fixture and accessories are used safely.
2. Ensure the 28mm Spigot is correctly mounted onto the yoke before rigging.
3. Always use secondary safety cables of suitable length when hanging TruColor HS
lampheads or PSUs.
4. The TruColor HS lamphead weighs 12 lbs. (5.5 kg) excluding accessories and the PSU
weighs 12 lbs. (5.5 kg). The combined weight should be considered when choosing a
suitable safety cable.
5. Safety cables must securely be attached to the designated slots on TruColor HS (detailed on
page 4) and be as short as possible to reduce travel distance if primary hanging accessory
fails.
6. Ensure that the yoke lock is correctly tightened when manipulating TruColor HS in the
required orientation for safety purposes.
7. Ensure TruColor HS lamphead and DX450 are operated within an ambient temperature
range of -20 to +50°C (-4 to 122°F).