Clay Paky ALPHA SPOT HPE 700 (C61355) - Manual (Page 10)

10 ALPHA SPOT HPE 700
Save To
Preset 3
SHUTTER
Shutter on error
Used for automatically closing the stop/strobe in the event of Pan/Tilt
position error.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off)
automatic stop/strobe closing in the event of Pan/Tilt position error.
3) Press F to confirm the selection, or LEFT D to keep current settings.
Dimmer on Shutter
Enables automatic closing of the dimmer when the strobe is completely closed.
1) Press
F – the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off)
the automatic closing of the dimmer.
3) Press F to confirm the selection, or LEFT D to keep current
settings.
POWER MODE
Allows you to select a Power Mode from the three available.
1) Press
F - the current settings appear on the display.
2) Use the UP B and DOWN C keys to select one of the following settings:
- 4-700W Full fan speed: Lamp can change from full-power (700W) to
half-power (400W) using the LAMP CONTROL channel. Fans always
work at Full speed.
- 400W Low fan speed: Lamp constantly works in half-power mode
(400W) while the Fan always works at Low speed. With LAMP
CONTROL channel you can only switch the lamp ON and OFF.
- 4-700W Auto fan speed: Lamp can change from full-power (700W) to
half-power (400W) using the LAMP CONTROL channel. Automatically
the fans switch from Full speed to Low speed respectively.
3) Press F to confirm the selection or LEFT D to keep current setting.
DISPLAY
Used for automatically reduce brightness on the display after about 30
seconds in idle.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off) the
decreasing of display brightness.
3) Press F to confirm the selection or LEFT D to keep current settings.
SETTING
Used to save 3 different settings of the items in the options menu and
relative submenus.
1) Press
F - “Default preset” appears on the display.
2) Use the UP B and DOWN C keys to select one of the following
configurations:
- Default preset (*)
- User preset 1
- User preset 2
- User Preset 3
3) Press F - “Load preset X” appears on the display.
4) Use the UP B and DOWN C keys to select:
- Load preset X to recall a previously stored configuration.
- Save to preset X to store the current configuration.
a confirmation message (Are you sure?) appears on the display.
5) Select YES to confirm the selection or NO to keep the current setting
and return to the next higher level.
(*) DEFAULT PRESET
By pressing the RIGHT
E key and the LEFT D key simultaneously
once entered in the "main menu" it is possible to quickly (short cut)
reset the default settings (DEFAULT PRESET).
Reset To
Dafault
Go Back
Setting
Default
Preset
Load
Preset 1
Save To
Preset 1
User
Preset 1
Load
Preset 2
Save To
Preset 2
User
Preset 2
Load
Preset 3
User
Preset 3
On
Off
Display
Shutter
Shutter
On Error
On
Off
Dimmer On
Shutter
On
Off
Power Mode
4-700W
Full fan speed
400W
Low fan speed
4-700W
Auto fan speed