Performance dc – Clearaudio PERFORMANCE DC User Manual
Page 9
Performance DC
User manual
Page 9
Clearaudio electronic GmbH 2014
2.8
For tonearm and cartridge mounting please refer to the user manual of the respective
manufacturer.
Now you can connect the
Performance DC
turntable with the main supply.
2.9 Speed fine adjustment
As the motor adjustment is already pre-set at the factory, you don’t have to check the speed before
using the turntable for the first time.
If you want to check the speed of your turntable by yourself over the time, we recommend to use a
Stroboscope Testrecord.
To adjust the speed so perfectly and precisely as possible, we recommend the Clearaudio
Stroboscope Testrecord (AC038) and the Clearaudio “Speed Light” (AC039) (both available at
On the backside (close to the power supply input) of your turntable there are three setting
trimmers:
- left trimmer = setting 45 rpm
(near power supply jack)
- middle trimmer = setting 78 rpm
- right trimmer = setting 33 1/3 rpm
Now you are finally ready to play your vinyl records!
Attention:
If the turntable is not in use, disconnect the unit completely from the power supply by removing the
main plug from the socket.
We wish you a lot of pleasure with your new
Performance DC
- turntable.
Pic. 9: Connection to the main supply
Pic. 10: Speed fine adjustment