Brocade Communications Systems Brocade Network OS 2.1 - Manual (Page 27)

Network OS Documentation Update 17
53-1002606-06
show lldp neighbors
2
show lldp neighbors
Displays LLDP information for all neighboring devices on the specified interface.
Synopsis show lldp neighbors [interface {tengigabitethernet rbridge-id/slot/port | gigabitethernet
rbridge-id/slot/port} detail]
Operands interface Use this keyword to specify an Ethernet interface using the following
operands:
tengigabitethernet Specifies a valid 10 Gbps Ethernet interface.
rbridge-id Specifies a switch by its RBridge identifier.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet Specifies a valid 1 Gbps Ethernet interface.
rbridge-id Specifies a switch by its RBridge identifier.
slot Specifies a valid slot number.
port Specifies a valid port number.
detail Displays all the LLDP neighbor information in detail for the specified
interface.
Defaults None
Command
Modes
Privileged EXEC mode
Description Use this command to display LLDP information for all neighboring devices on the specified
interface.
If you do not use the interface operand, only the mandatory TLVs are displayed.
Usage
Guidelines
The gigabitethernet rbridge-id/slot/port operand is used only on the Brocade VDX 6710.
Examples To display detailed LLDP neighbor information on a specific interface:
switch# show lldp neighbors interface tengigabitethernet 3/0/8 detail
Neighbors for Interface Te 3/0/8
MANDATORY TLVs
===============
Local Interface: Te 0/8 Remote Interface: Te 3/0/8 (IF Name)
Dead Interval: 120 secs Remaining Life : 100 secs Tx: 536 Rx: 535
Chassis ID: 0005.1e76.1020 (MAC)
Remote Mac: 0005.1e76.102c
OPTIONAL TLVs
==============
Port Interface Description: Te 3/0/8
System Name: sw0