Clearaudio STATEMENT - Manual (Page 8)

Statement
User Manual
Page 8  Clearaudio electronic GmbH 2013
IMPORTANT!
Being careful not to damage the bearing spindle on top of the pendulum shaft, assemble the
pendulum, starting by sliding a solid metal disc over the pendulum shaft so that it rests on the
wooden blocks. Be sure to place a felt mat between each metal disc, building the pendulum with
three solid discs at the bottom, then six half-cut-away discs, then two more solid discs, finally
adding the solid disc engraved with the words Clearaudio Statement.
Please note:
If you are using the Statement TT1 tangential tonearm, position the half-cut-away discs with the
cut-away section at the rear of the turntable.
3.
Place the four cork damping plates on top of the four corner
pillars.
Again, being careful not to damage the bearing spindle on
top of the pendulum shaft, lower the stainless steel cross
frame over the pendulum shaft so that it rests on the four
cork damping plates.
Disc engraved with
“Clearaudio Statement”
Disc, solid (2 pcs.)
Disc, half cut away
(6 pcs.)
Disc, solid (3pcs.)
Place a felt mat in
between each stainless
steel platters
Place 4 pcs. damping
plates if not assembled
already from the factory
Pic. 3: Placing the discs
Pic. 4: Placing the cork damping plates