CommScope ATC300-2000 - Manual (Page 48)

ATC300-1000/2000 Teletilt ® RET System Section 4–Changing IP Settings on the Local Computer Manually
Bulletin 639544 • Revision L August 2014 4-5
8. Enter an IP address that matches the controller’s IP address with the final digit one digit lower
(Example: Controller Factory Set IP is 192.168.255.141; New IP is 192.168.255.140). See Figure
4–5.
9. Enter a subnet mask that matches the controller’s Netmask exactly. The controller’s default Net-
mask setting is 255.255.255.0 (Figure 4-5).
10. Erase all other fields on the screen (Figure 4-5).
11. Click OK (Figure 4-5).
12. Close out of remaining dialog boxes. The local computer is now set up to access the controller.
Figure 4-5. Changing The IP Address On The Local Computer.
1. Enter IP address,
final digit 1 lower
than controller IP
address.
2. Enter Subnet
mask, exactly
match controller
Netmask setting.
3. Clear remaining
fields.
4. Click on OK.