CommScope ATC300-2000 - Manual (Page 6)

to return to the controller’s main screen when device configuration is complete.
Edit Selected 1. Select appropriate device to be configured and click on
3.0 Device Configuration
(Figure 3-1).
Figure 3-1. Starting the Device Configuration.
2. Make appropriate selections and text entries on screen below.
• To receive commands from the controller, a device must be configured to provide specific
information about the antenna and its location on site.
• Factory installed actuators are pre-configured to include the antenna model number, antenna
type, and antenna serial number.
• The remaining fields (Installation Date, Base Station ID, Mechanical Tilt, Technology, Freq. Band,
Sector, Location, Bearing, Height, and Installer ID) will need to be configured.
• After entering data, click on Set Device Data (Figure 3-2).
Note: Click on Close
Figure 3-2. Device Configuration.
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup
Bulletin 639572 • Revision F • December 2012 Page 6 of 7