M-216 battery charging battery charging – COMTEK M-216 User Manual
Page 7
Page 5
M-216 BATTERY CHARGING
Battery Charging
1.
Make sure that a seven cell 9 volt Ni-MH rechargeable
battery is used with a minimum of 200 mAh capacity.
(Alkaline batteries must not be charged.)
2.
Make sure the M-216 is turned OFF.
3.
Note that the red charging indicator on the charger is ON when the M-216
is plugged into the charger through the auxiliary audio input jack.
4.
When using the NBC 9-2C charger allow the battery to charge for 14 hours
for a full charge. Unit must then be unplugged. When using the
NBC 9-3-1 digital fast charger the charger will automatically end the
charge cycle and the red LED will change to green. With the NBC 9-3-1
charger the unit may be left in the charger until the unit is used.
5.
Periodically open the battery compartment on stored COMTEK units to
check for battery leakage. If a battery is leaking, it must be discarded,
and the battery compartment must be cleaned or returned to COMTEK’s
service department for repairs.
IMPOR
TANT
NBC 9-2C
14-hour charger
NBC 9-3-1
digital fast charger