Tools needed, Esc wiring – DJI F550 v1.8 User Manual
Page 5
©2012 DJI Innovations. All Rights Reserved.
5
Tools Needed
2.0mm Hex Wrench
For frame and motors installation.
Screw Glue
For fastening screws.
Nylon Cable Tie
For binding devices and wires.
Scissors
Diagonal Cutting Pliers
Foam Double Sided Adhesive Tape
For fixing receiver, controller and other modules.
Soldering-iron & Wires
For connecting ESCs’ power cables to bottom board.
ESC Wiring
Important
Please solder ESCs to power pads on bottom board as the figure shows.
Use any insulating method at all soldering spots. Make sure there is no short or open circuit.
Make sure the side of power pads is upward.
Make sure the rotation direction of each motor is the same as the way in the figure of
“
Assembly
” shows. If not, switch any of two wire connections of the incorrect motor to change
its rotation direction.
ESC
To Battery
Power Pads
ESC
ESC
ESC
ESC
ESC