DJI Phantom 2 FPV HUB Kit - Manual (Page 3)

©2013 DJI Innovations. All Rights Reserved.3 |
module, connect it to the FPV HUB via HUB-VTX cable according to
pins description of the HUB-VTX cable.
GND
GND wire from PHANTOM 2, connect it to the GND port of wireless
video transmission module.
VCC
Power wire from PHANTOM 2 provides 1.5A@12V power. Connect it
to the VCC port of wireless video transmission module.
VIDEO_GND
GND wire of analog video signal, connect it to the VIDEO_GND port
of wireless video transmission module. If the video transmission
module used has only one GND port on the transmitter, it’s alright to
connect both GND and VIDEO_GND to the only GND port.
VIDEO
For analog video output, connect it to the video input port of the
wireless video transmission module.
Collocation 2&3: iOSD mini/iOSD MARK II and video transmission
module connected
To the CAN-
BUS Connector
of PHANTOM 2
HUB-iOSD mini cable
Micro switch stops at
OSD
Connecting with the
8-Pin cable reserved
in PHANTOM 2
HUB-ZEN cable
HUB-AVL58 cable
A V L 5 8
T R A N S M I T T E R
HUB-iOSD Mark II cable
To the CAN-BUS
Connector of PHANTOM 2
H
U
B
-V
TX
c
ab
le
DJI unspecified wireless video
transmission module
1) It’s alternative to use iOSD mini or iOSD Mark II.
2) Stop the Micro switch at OSD position when iOSD is connected to