Assembly, Position switch control – DJI iOSD MARK II User Manual
Page 5
©2012-2013 DJI Innovations. All Rights Reserved.
5
Assembly
1.
Fix the iOSD controller on your aircraft.
2.
Connect the iOSD with the video signal source, wireless video TX module, DJI autopilot system and R/C
receiver. Make sure the connection is correct in accordance with the wiring diagram.
3.
Setup a 3-position switch on the R/C TX as the iOSD control switch.
4.
Connect your wireless video RX module with the display screen.
Please refer to DJI autopilot system manual, your TX manual, and your
wireless video RX
for more details.
3-Position Switch Control
Choose a 3-position switch and make sure you connect the correct channel of the receiver to the iOSD switch port.
Position -1 Position -2, (hold position -2 for 1.5s)
: every toggle from
Position -1 to Position -2 increases
the
channel of the wireless video transmitter
module by 1 (from CH1 to CH8), only for the wireless video
transmitter module specified by DJI.
Position -3 Position -2, (hold position -2 for 1.5s)
:
toggle the switch to select the required video input, when
there are two video inputs.
Only the toggle from
Position -3 to Position -2 can change the video input source.
AV1 is default.
Position -1 Position -2 Position -3