Bissell QuickSteamer 1770 series - Manual (Page 7)

Hard floor cleaning
(included on select models only)
1. Remove the collection tank (refer to steps 2a and
b in the "To empty the collection tank" section on
page 6)
A. For 1770/1970 series it is necessary to
remove the cross action brush first.
Using your thumbs squeeze the 2 grey tabs
towards the outside of the unit. Push down
at the same time and release
the cross action brush.
2. Attach the hard floor tool by hooking it into the
front of the removable nozzle and swinging it
down until the tabs pop into place.
3. Replace the collection tank. Be sure to attach the
two latches.
4. Fill solution tank with BISSELL 2X Hard Floor
Solutions™ to FORMULA fill line. Fill the rest of
the tank with hot (not boiling) tap water to the
WATER fill line. Replace and tighten the black cap.
5. Follow steps 1-8 in "Carpet Cleaning" section
above.
7
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
2.
2.
1770/1970 series
2080/2090 series
O
peration
OR
WARNING:
To reduce the risk of fire and electric
shock- when cleaning a hard floor,
the BISSELL hard floor tool 203-5637
(models 1770 & 1970) / 203-5639
(models 2080 & 2090) must be
used and it must only be used with
BISSELL Hard Floor Solutions or
BISSELL 2X Hard Floor Solutions
cleaning fluid intended for use with
this appliance.