Metrohm 807 Dosing Unit - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
846 Dosing Interface
￭￭￭￭￭￭￭￭ 15
Figure 7 Connecting a dosing device
3.4.2 Connecting a stirrer or titration stand
You can use a magnetic stirrer 801 Stirrer or 803 Ti Stand (stirring "from
below") or the 804 Ti Stand with a propeller stirrer 802 Stirrer (stirring
"from above").
Connect a stirrer or a titration stand as follows:
1 Connect a stirrer or titration stand
￭ Exit the control software.
￭ Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the control instrument.
￭ If desired, connect the propeller stirrer to the stirrer socket (with
stirrer symbol) of the titration stand.
￭ Start the control software.
Figure 8 Connecting an MSB stirrer