Blaupunkt MINNESOTA DJ32 - Manual (Page 18)

40
Scanning all the tracks on a
cassette (SCAN)
➮
Keep the MENU button
7
pressed
for longer than two seconds.
“CAS SCAN” appears in the display. All
the tracks on the cassette are briefly
played in ascending order.
To stop scanning,
➮
Press the MENU button
7
again.
The current track will then continue to
be played.
Note:
●
You can set the scanning time. For
further details, read the section en-
titled “Setting the scantime” in the
“Radio mode” chapter.
●
In order for the S-CPS, RPT and
SCAN functions to work properly,
there must be a pause of at least
three seconds between each track
on the cassette.
Pausing playback (PAUSE)
To pause the cassette whilst it is play-
ing,
➮
press button 3 ( )
:
.
Playback is paused and “PAUSE” ap-
pears in the display.
➮
Press button 3 ( )
:
again to
cancel pause.
Skipping blank spaces
(blankskip)
You can automatically skip blank spac-
es on the tape that are longer than ten
seconds. To do so, the “blankskip” fea-
ture must be activated.
Note:
●
You can switch “blankskip” on/off
whilst a cassette is playing.
Switching blankskip on/off
➮
Press the MENU button
7
.
➮
Keep pressing the or button
5
until “BLK SKIP” appears in the
display.
➮
Press the or button
5
to
switch blankskip on/off.
When you have finished making your
changes,
➮
press the MENU button
7
.
Selecting the tape type
If you play a “metal” or “CrO
2
” tape type,
you should set the tape type to “MTL
ON”.
To select the tape type,
➮
press button 1 (MTL)
:
.
“MTL ON” or “MTL OFF” appears brief-
ly in the display.
Dolby* B noise suppression
If you play cassettes that were record-
ed using the Dolby B process, you
should switch on the Dolby feature.
➮
Press button 6 ( )
:
.
If the Dolby feature is activated,
lights up in the display.
* Noise suppression system manufactured under license
from Dolby Laboratories. The word “Dolby” and the dou-
ble-D symbol are trademarks of Dolby Laboratories.
CASSETTE MODE