Brother XL5050 - Manual (Page 34)

33
Adjusting Buttonholes
If the stitching on the two sides of the buttonhole is
not the same, you can make the following
adjustments.
1
Set the stitch length dial to " " and sew the
buttonhole on a scrap piece of fabric to
observe how the material is fed.
2
If the right side of the buttonhole is too coarse
or fine, adjust the feeding of the material with
the Stitch Length Dial.
1 Right side
2 Shorter
3 Longer
3
After obtaining a satisfactory feeding on the
right side, stitch the buttonhole and observe
the feeding.
4
If the left side is too coarse or fine compared
with the right side, adjust the buttonhole fine
adjustment screw as described below.
If the left side is too coarse, turn the buttonhole
fine adjustment screw with a large screwdriver
in the - direction.
If the left side is too fine, turn the buttonhole
fine adjustment screw with a large screwdriver
in the + direction.
• This adjustment ensures both sides of the
buttonhole are the same.
1 Stitch length dial
2 Buttonhole fine adjustment screw
3 Left side
4 In this case
Sewing Buttons
1
Measure the distance between the holes and
select the appropriate pattern with the pattern
selection dial.
2
Attach the button sewing foot.
1
2 3
0
2
1
2
3
2 2
0 1 0 1
Stitch
Name Pattern
Stitch
Length
[mm (inch)]
Stitch
Width
[mm (inch)]
Foot
Zigzag
Stitch
(1/64)
1.7
(1/16)
Button
Sewing
Foot
Zigzag
Stitch
(1/64)
3.5
(1/8)
Zigzag
Stitch
(1/64)
5
(3/16)
3
4 4
1
2
XL5000us.book Page 33 Tuesday, November 11, 2003 9:25 AM